Pavement Preservation Glossary of Treatment Terms (Ⅳ)
Microsurfacing – A mixture of polymer modified asphalt emulsion, mineral aggregate, mineral filler, water, and other additives, properly proportioned, mixed, and spread on a paved surface. Microsurfacing differs from slurry seal in that it can be used on high volume roadways to correct wheel path rutting and provide a skid resistant pavement surface.
Modified Asphalt Chip Seal – A variation on conventional chip seals in which the asphalt binder is modified with a blend of ground tire or latex rubber, or polymer modifiers to enhance the elasticity and adhesion characteristics of the binder.
Open-Graded Friction Course (OGFC) – A thin HMA surface course consisting of a mix of an asphalt binder and open-graded (also called uniformly graded) aggregate. An OGFC helps to eliminate standing water on a pavement surface, which reduces tire spray and hydroplaning potential.
Over-banding – Over-filling of a joint or crack reservoir so that a thin layer of crack or joint sealant is spread onto the pavement surface center over the joint or crack
Partial-Depth Patching – Repairs of localized areas of surface deterioration of PCC pavements, usually for compression spalling problems, severe scaling, or other surface problems that are within the upper one-third of the slab depth.
Patch – Placement of a repair material to replace a localized defect in the pavement surface.
Paver Placed Surface Seal – Also known as Nova Chip® and bonded wearing course. Anultra-thin, open graded, hot mixed asphalt friction course placed over a heavy application of polymer-modified asphalt emulsion. The material is laid using specially built equipment which spreads both the asphalt emulsion and hot mix asphalt in a single pass. The material is placed at an average thickness of ⅜” (10 mm) to ¾” (20mm).

















